Ryobi RY10520 Manuale dell'Operatore Scaricare il pdf (Pagina 13)

Page 13 — English

FILLING THE FUEL TANK

See Figure 2.

Clean the surface around the fuel cap to prevent

contamination.

Loosen the fuel cap slowly.

Carefully pour the fuel mixture into the tank.

Avoid spillage.

Prior to replacing the fuel cap, clean and inspect the

o-ring.

Immediately replace the fuel cap and hand

tighten. Wipe up any fuel spillage.

NOTE:

It is normal for the engine to emit smoke

during and after the first use.

Fig. 2

ADDING BAR AND CHAIN LUBRICANT

See Figure 3.

Use RYOBI Bar and Chain Lubricant. It is designed

for chains and chain oilers, and is formulated to

perform over a wide temperature range with no dilu-

tion required. Chain saw should use approximately

one tank of lubricant per tank of fuel.

NOTE:

Do not use dirty, used, or otherwise con-

taminated lubricants. Damage may occur to the

oil pump, bar, or chain.

Carefully pour the bar and chain lubricant into

the oil tank.

Fill the oil tank every time you fuel the engine.

Fig. 3

OPERATION

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 40 41

Nessun commento

Ryobi RY10520 Manuale dell'Operatore Pagina 13