Ryobi DBJ50 Istruzioni per gli Interventi Scaricare il pdf (Pagina 122)

Page 113 Power Equipment Usage Manual (Rev. 5/10)

27. SANDER, WIDE DRUM (Timesavers S311-13-1T)

The dual roller, single drum sander can sand wood up to 36” wide. The grit of the

belt is 80, which is the grit we have on all the stationary sanders.

27.1. Safety Precautions

Members are required to attend a short class on the use of the sander. One

cannot use it unless they have taken the class and have their name on the

“APPROVED USERS” list at the Shop Monitor’s desk.

a. EMERGENCY STOP BAR – If the unit needs to be stopped

IMMEDIATELY during any operation, press the RED stop bar

located across the front of the equipment at the infeed. Once

stopped, lower the infeed table before attempting to remove

the workpiece.

b. DO NOT SAND material shorter than 12”, narrower than 3/4” or

thinner than 1/8” thick.

c. DO NOT SAND very small or very thin workpieces that cannot be

safely controlled. Loss of control of the workpiece can result in

injury. If a workpiece is thinner than 1/8”, you must use a backer

board when sanding.

d. NEVER stand directly in line with either the infeed or outfeed sides. Stand to one side.

e. NEVER TURN THE MACHINE “ON” with the workpiece contacting the abrasive surface. Kickback

can occur.

f. AVOID AWKWARD OPERATIONS AND HAND POSITIONS – NEVER place your hands directly at the

front opening of the infeed. A sudden slip could cause a hand to move into the abrasive disc or

belt.

g. PROPERLY SUPPORT LONG OR WIDE WORKPIECES. Loss of control of the workpiece is

dangerous.

h. NEVER PERFORM LAYOUT, ASSEMBLY, OR SET-UP WORK on the table/work area when the

machine is running. A sudden slip could cause a hand to move into the abrasive surface. Severe

injury can result.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 138 139

Nessun commento

Ryobi DBJ50 Istruzioni per gli Interventi Pagina 122